Originally Posted by chicagoslick
They will not work with mine. I would have to take at least 1 1/2 inches...My axles are too close...
So now I have nice new set sitting in the garage...
I cut about 1 1/2 inches off of mine and re-rounded leading edge. I have not cut the back corner like OC but will do that next for a little extra clearance. I used a saw to cut 1 1/2 inches off and an orbital sander to round the edges. I then used a propane torch to melt the surface a little to get back the shine in the finish.
My leading edge is now about 1 inch (rather than 1/2 inch). I was using lynx levelers prior with success which are 1 1/2 inch. The way I look at it is, I am a 1/2 lower to start with these and are not restricted to 1 1/2 inch increments.