Fog light

dogsgocamping · 11-07-2015, 11:44 PM

Does anybody know where to get replacement fog lights for a 2011 Berk? One of our lenses is cracked.

Sent from my SCH-I535 using Tapatalk

fredhardy · 11-08-2015, 02:15 PM

I spoke to my local dealer about replacing a broken lens and was told that FR parts will only sell the fog lights in pairs. So I replaced mine with LED fog lamps.

dogsgocamping · 11-08-2015, 02:52 PM

Would you please share which ones you purchased? Part number etc.

Sent from my SCH-I535 using Tapatalk

gasman94 · 11-08-2015, 02:53 PM

Had same issue and had them replaced at Goshen rally. There are some that might work on Amazon. Need to crawl under front to see wiring and attachment points.

Rich

BooBoo23 · 11-08-2015, 03:55 PM

Can you see the part # on the lens? It is usually embossed on the surface and hard to see but if you take a thin piece of paper and rub a pencil over it you can see it. It may be a fairly common lens that you may be able to find on Ebay or do a Google search for that part #.

BooBoo23 · 11-08-2015, 03:59 PM

Can you see a part # on the lens? It is usually embossed in the plastic or glass around the top edge but sometimes hard to see but if you take a thin piece of paper and rub a pencil over it you can transfer the numbers and be able to look on Ebay or do a Google search for that number.

dogsgocamping · 11-08-2015, 05:34 PM

I was thinking of going led. That would be an assembly I assume.

Sent from my SCH-I535 using Tapatalk

BooBoo23 · 11-09-2015, 07:44 PM

If it is not a sealed unit you can probably find a LED replacement for the filament bulb. Is the lens removable? If so, Google for a LED replacement match.

outloud · 11-15-2015, 06:19 PM

? Where is the switch for the fog light have a 2010 BH with the lights but have not found the switch.

Sent from my iPhone using Forest River Forums

dogsgocamping · 11-15-2015, 06:42 PM

Push on push off using the light switch. Must be on low beam to work

Sent from my SCH-I535 using Tapatalk

fredhardy · 11-15-2015, 09:40 PM

I checked the lens cover for the OEM fog lights I removed and there are no identifying #'s or marks. The lights I installed are heavy duty hi-intensity "off-road" lights that I intend to use for daylight driving only.
Part info: ANZO, 3x3 LED. # 861159 square, approx $100
To all owners: if you climb underneath and look at the installation of the OEM fog lights, the installation studs off the lights only have small star washers and nuts securing the lights. I recommend additional flat washers be added to bear the load of the lights. My lights were pulling the star washers thru the fiberglass.
Regards, Fred

You may also like: