Any one out there able to tell me where my ecm or computer connection is? I have looked all under the dash around the steering column but just cannot find it. I need to plug up a scangauge to it. The rig is a 2010 Georgetown 337 v-10.
On my 2008 it's on the steering column on the right side at about knee level. It's covered by a cap that says "CONNECTOR" on it. I had to remove the kick panel under the steering wheel to get to it.
My OBD-II/EOBD scanner connected up and read the codes just fine.
__________________
2008 Georgetown SE 350DS BunkHouse
The port is on the right side of the steering column attached to a bracket. It's about knee height and just under the dash. It has a black cap over it that reads "CONNECTOR" there's a blue outline behind it.
I popped off the cap and there it is.