Thread Tools Display Modes
Old 05-07-2012, 08:57 PM   #1
Junior Member
Join Date: Feb 2012
Location: Dayton
Posts: 16
Removing Furnace in 2004 Georgetown 303

I need to remove the furnace to get to the fan motor that's rubbing. Any tricks? Is it just laying over the opening with a couple screws on the accessible side? The propane line is on the right and easy to remove. Hopefully the wires will have enough slack to pull it out. Thanks for any help... Jim

Dayton, Ohio
kick is offline   Reply With Quote
Old 05-09-2012, 06:37 PM   #2
Senior Member
jsutherl's Avatar
Join Date: Nov 2010
Posts: 312
On my 2008 it was only held down by three screws screwed into the floor on the opposite side of the heater frame from the vent.

The wires on mine where not long enough. I had to cut them and install insulated spade connectors to put it all back together.

The vent fitting is screwed into the side of the coach. The heater pushed onto the vent fitting from inside and on mine it was kind of tight. So basically I removed the gas line, cut the wires, removed the three screws and then pulled pretty hard to get the heater off the vent stack.

While you have it out you might as well open the burner compartment and blow it out. It gets all sooty in there and sometimes will prevent the heater from lighting reliably. That's why I had to remove mine.
2008 Georgetown SE 350DS BunkHouse
jsutherl is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

» Featured Campgrounds

Reviews provided by is not in any way associated with Forest River, Inc. or its associated RV manufacturing divisions.

Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -5. The time now is 09:46 AM.