All of us in SoCal know that today was windy, some bouts of extreme downpour, some lightning too, etc.
When it cleared and was beautiful I went over to look at my TH and I noticed a little water on the floor coming out from under the slide out (which is IN at the moment as the TH is stored). I took the panel out so I could see under and saw it kept going towards the wall. I then felt around and saw the water was coming up the slide out inside, so I stood on my sofa and looked up top and this is what I see....
I want to note that the rubber looks like it is pressed in, but I did that in investigation. It was seamless across the entire thing inside. Technically it is the outside rubber seal that should be doing it's job. But it isn't. I have an Apt 3/28. This is probably the 6th time I have taken this 2016 in
Linear Mode
