When you buy your solar panels, one lead will be marker + POSITIVE and will be a male MC4 connector. And the other - NEGATIVE and a female MC4 connector. Once you have that, the wire ends inside will be the same. If there are no ends, you will need a ohm meter to determine which wire is which. These wires will go to the controller's input/ solar panel connections.
I installed a 30 amp breaker in the positive wire before the controller so I can disconnect the panels if I need to work on the controller.
Using a volt meter determine which wire goes to the positive on the battery and connect those wires to the controller's output.
__________________
2015 Jeep JK Rubicon
2019 Rockwood A122S
|