Camper not level

[SYOTR]

I have a new 2015 194HW A frame camper. On my first excursion, I noticed that it does not sit level when being towed. One side is almost 2" higher than the other, even with no water in the tank. I have checked it on a level garage floor, disconnected from the tow vehicle.
Is there a way to adjust this?

[TheWolfPaq82]

Originally Posted by SYOTR

I have a new 2015 194HW A frame camper. On my first excursion, I noticed that it does not sit level when being towed. One side is almost 2" higher than the other, even with no water in the tank. I have checked it on a level garage floor, disconnected from the tow vehicle.
Is there a way to adjust this?

I'd be heading back to dealer with that one.

[SeaDog]

I'm sure your rig is out of warranty I believe what I would do is take very detailed measurements (after talking to the spring shop) and then take the spring on the low side to a spring shop and have it re-arched to bring the rig back to level. I did this on my Class A with great results.

[SYOTR]

I purchased it new in Oct 2016. It is a 2015 model. I expect it should be in warranty. There are no springs visible, just a torque arm.

[SeaDog]

Originally Posted by SYOTR

I purchased it new in Oct 2016. It is a 2015 model. I expect it should be in warranty. There are no springs visible, just a torque arm.

Take it to the dealer if its in warranty and let them deal with it. It may as simple as adjusting the torque tube on that side. I assumed it was bought in 14 or 15 and that it had springs but you know what assume stands for!

[SYOTR]

Originally Posted by SeaDog

Take it to the dealer if its in warranty and let them deal with it. It may as simple as adjusting the torque tube on that side. I assumed it was bought in 14 or 15 and that it had springs but you know what assume stands for!

I was hoping it was something I could adjust. I don't see any way to do that. Guess I will have to take it to a dealer.
Thanks for the response.