Wondering if anyone might know what material the front panel on a 2304KS Rockwood Mini Lite is made of, fiberglass?
I had a minor collision with a tree branch, took out the marker light on the front left top of unit and cracked the panel behind the light. Material looks like fiberglass gel-coat over some kind of fiber board from what I can see.
Was thinking I could it to rough up a bit and glass over it, opinions?
__________________
Dan-Retired California Firefighter/EMT
Shawn-Musician/Entrepreneur/Wine Expert
and Zoe the Wonder Dog(R.I.P.)
2016 PrimeTime TracerAIR 255, pushing a 2014 Ford F150 SCREW XTR 4x4 3.5 Ecoboost w/Max Tow Package
4pt Equal-i-zer WDH and 1828lbs of payload capacity
maybe super glue the ends of the cracks also, then a thin sheet of woven f-glass applied, marking where the previous light holes are... maybe think about a very small amount of Gorilla glue into those holes so light housing screws have something to dig into... (makes a hard expanded foamy substance when hard)
I bought an exact replacement side marker light on some website... someone pointed me to it... maybe can do it again as I don't recall.
hopefully not too bad to repair and probably only you will know it is patched there...
good luck
__________________ "nothing can now be believed which is seen in a newspaper. Truth itself becomes suspicious by being put into that polluted vehicle." Thomas Jefferson to John Norvell pg. 2, June 11, 1807 2014 Shamrock 183
2014 RAM 1500 Bighorn Crew Cab, HEMI, 3.21 gears, 8 Spd, 4X4 TST TPMS
Rough it up and glass over it. Get a color match and see if a car repair shop will be able to mix a gloss for you. Before you do any repair, check inside for any structural damage to support system.
2304KS Rockwood Mini Lite Cracked front panel
Linear Mode
