Since I purchased this MH used and don't have any real history on it I'm planning on sealing/caulking the roof to side wall seam.
So you can see the roof membrane raps around to join the side wall. What is my best bet to make sure I get a good seal? Should I try to remove the hole trim strip and add butyl tape behind it the reattach and silicone (or dicot) above and below? Or should I clean up the existing sealant and reseal?
Also there are a few "bumps" along the roof radius. It is barely visible in the center of the pic. Is this an area of concern?
I will be bringing it home from storage on Friday night. Will be working on parts of the floor (see sub floor repair thread). Also want to make sure ALL of the leaks are resolved before I start putting in new sub floor.