Hello all.
My Rockwood Signature Ultra-Lite model 8318SS has developed some issues near the rear bunk slide out.
I think I have a couple of issues here.
At some point someone damaged the side wall around the slide out. I don't know if they failed to remove the supports prior to operating the slide out or not but we noticed that the wall above the slide out was not as strong as the rest of the camper about a month after we bought it. I can tell there was some work done around the outside.. replaced caulk, slide seal on the right side of the slide is different from the one on the left, and the top seal is different as well. It's pretty obvious that they were replaced at some point which makes sense.. that's the area that was weak.
On the exterior fiberglass there was a small surface crack that I repaired last year with some caulk (see attached photo).
Just this spring I've noticed there top of the wall getting progressively worse too the point now that I'm really careful when operating the slide for fear that it's going to break the wall. There is visible movement when I extend or retract the slide. Upon looking closer I noticed that there crack I'd repaired last spring has gotten worse and spread straight up. Bad news is it's right under the gutter and my guess is that water has been pouring into the wall and further weakened the structure. Delamination is present in that corner and the slide out topper bracket is loose.
At this point all I care about is sealing it up and reinforcement of that area so it doesn't break. We would like to get a few more years out of the camper.
Any advice you can give would be greatly appreciated.
Thanks.