2015 26RLWS Bedroom Slide Out Not Working

[1300r]

New to the site.

Our bedroom slide out (closet) has all of a sudden stopped working.

I was recently in the trunk area doing some maintenance work and sealing up holes to prevent lady bugs and ant's from getting into our living area.

Looking for clues on what might be the issue and the solution.

Thank you.
E

[hammer55]

what kind is it

Originally Posted by ericvtx1300r

New to the site.

Our bedroom slide out (closet) has all of a sudden stopped working.

I was recently in the trunk area doing some maintenance work and sealing up holes to prevent lady bugs and any from getting into our living area.

Looking for clues on what might be the issue and the solution.

Thank you.
E

[1300r]

2015 Forest River Super Lite Flagstaff 26RLWS

E

[AquaMan]

Was slide working before you were in the storage area, and then wasn't after? If so I would start my search there for a loose wire. Check fuses. Look for a possible inline fuse near slide motor. What type of slide out do you have? If not sure, a Picture will help those of us who don't have this unit.

[hammer55]

this was my ? What type of slide out do you have?

Originally Posted by ericvtx1300r

2015 Forest River Super Lite Flagstaff 26RLWS

E

[AquaMan]

Originally Posted by hammer55

this was my ? What type of slide out do you have?

That's what I figured, but I could see how the OP was confused by "What kind is it?".

[fonzie]

for the bedroom slide, it seems that he has the Schwintek system.....see picture


2015 Forest River Flagstaff 26RLWS, Grain Valley MO - - RVtrader.com

[1300r]

Here is the only photo that I currently have.

[raspivey]

It's a Schwintech. Find the synchronizer box...probably in the front storage compartment and see if it's flashing any codes.

[fonzie]

Lots of info here.....

https://www.google.ca/search?q=schwi...AeKujgSYxoO4BA


https://www.youtube.com/results?sear...chwintek+slide

[raspivey]

I snagged a wire on my controller with a tiki torch once. Pulled the wires out a little on one side. Caused the motors not to work until I plugged it back in good.

[mule]

Your syncrenizer box being referred to is in the house filter compartment, outside, under your bedroom slide out, mounted close to the filter assembly.
FYI

[1300r]

I checked the controller and it doesn't have any LED's flashing. I checked the fuse panel located in the inverter and did not find any blown fuses.
Back to the drawing board...

[cat1956]

Look under the front of the trailer slide side. You may have two or three inline fuses. Check them.

[raspivey]

Originally Posted by ericvtx1300r

I checked the controller and it doesn't have any LED's flashing. I checked the fuse panel located in the inverter and did not find any blown fuses.
Back to the drawing board...

From there, I'd check and make sure there's power going into the control box.

[1300r]

People thank you. I located the blown fuse under my TT, front on the slide out side. Replaced the 30A, and it works like new again.
Now I just have to remember that for the future.

Thanks again!
E