have 2015 Sabre. When I move the slide out that has the dinning table and recliners it will go so far and then there is a load clunk. It will continue after that one load clunk. No clunk when retracting. Could I have a broken tooth on the gear?
Some slides (like mine) make that noise. Inspect both sides of the slide gear rack and the gear pack itself for tightness and see if any teeth have been broken.
__________________
Retired Navy
Jake my sidekick (yellow Lab) 10/04 - 05/20
2017 RAM 2500 CC 4X4 Cummins Diesel
2016 Flagstaff 26 FKWS
AF&AM & El Korah Shrine of Idaho
thanks I will check that out. If it was a broken tooth I would think it would do the hesitation and "clunk" going in and out, not just going out. Thanks again