Wobbly dinette table

[sherrycalh]

Morning... We just purchased a used RV. The dinette table is located on a slide. It's on 2 pedestals. One is obviously not attached to the floor well. The table is very wobbly. How do we fix this situation?

[rocco52]

I had the same issue. The only thing that you can do is to use bigger screws. Make sure to measure against the old ones so that you don't go all the way through the bottom. This can scratch the floor when the slide out is pulled in.

[ben31]

I added a third pedestal to my dinette table, on my previous RV. I found one (same length) at the Camping World store. I removed one of the screws from one of the existing pedestals, and matched the screw length for the new pedestal. Installed it and it never wobbled again.

Sorry, but I can't get to the photos of it, since my main computer is in storage.

If you tell us what model RV you have, we can better suggest how to arrange the pedestal legs, if you want to go the three-pedestal route.

[rk06382]

Originally Posted by sherrycalh

Morning... We just purchased a used RV. The dinette table is located on a slide. It's on 2 pedestals. One is obviously not attached to the floor well. The table is very wobbly. How do we fix this situation?

Quote below from FR3 Pictures of Mods: Table legs Post.
I replaced the Dinette table legs with Sequoia table legs. I was able to purchase local for less than Amazon but included link to clarify.
Amazon: 27'' Sequoia Table Leg








We travel with our son and my DW did not like stepping on the old table base when she sits in the back. She likes to go barefoot in the RV.

The Sequoia table legs locked the base of the legs. This also stabilize the table legs. I reused the original screws,