34RL slide topper question

[97flhtcui]

Anybody here have a 34rl with factory installed slide topper? I need to know the model number of the topper on the door side slide. It is on the build sheet that came with your RV. The reasoning behind this request is the awning is very close to that slide and when I order the topper I want to make sure it is the one they put on at the factory. Thank you .
Jack

[Jim34RL]

I have the 34RL with the factory ordered slide toppers. When I ordered the trailer the number used for the toppers was 6402; this will get you all three slide toppers. No individual part numbers for the toppers are on the price list that I have. The cost is $993 for the three toppers. These will fit the following models 34RL, 36CKTS, 38CK and 38FB2 for the early 2016 models. You will also need to order the Black A&E awning toppers with metal caps part number 6402-3, if you want the metal wrap.This is an additional charge of $190 each but if ordered from the factory with the slide toppers the cost is $400 total.
Hope this helps?

[97flhtcui]

Thank you Jim, there is a clearance issue with the awning and the corner with the slide. I measured and with the slide out and the awning out, the awning arm is 1 1/2" from the slide flange. That is not leaving any room for the topper hardware. I am going to buy them after the rally and installed so they can worry about the clearance.

[Jim34RL]

The slide topper on the curb side on my unit is mounted flush with the edge of the side nearest the door. The slide edge and the topper hardware are about 1 1/2 inch to two inches away from the awning support arm.
If you are ordering the trailer I would let Cedar Creek do the installation of the toppers at the factory they will make sure there is no interference with the awning support arm.