I have a 2015 Dynaquest 320xl. It has a heater in the wet bay. I have the rv plugged into shore power. Does it kick on automatically at a certain temp or is there a switch I can’t seem to find ? Also do the heater pads for the tanks kick on or is there a switch ?
I have a 2015 Dynaquest 320xl. It has a heater in the wet bay. I have the rv plugged into shore power. Does it kick on automatically at a certain temp or is there a switch I can’t seem to find ? Also do the heater pads for the tanks kick on or is there a switch ?
If it’s similar to our 2018 Dynaquest... the heat is tied to a blower below our washer/dryer and comes on with the rear zone.
If it’s similar to our 2018 Dynaquest... the heat is tied to a blower below our washer/dryer and comes on with the rear zone.
The 2015 has a different heater. It was a 12V auxillary heater similar to what we ran in the 28SS. It was thermostatically controlled...,but I'm not sure at what temp. The stuff today now has the temp visible in an app.
__________________ If "Search this Forum" does not yield answers, please post questions as a "New Thread" (instead of asking privately) so others can benefit from the answers.
Yes...in theory. I don;t know how accurate the thermostat is. In 2016, it changed to a duct off of the Aqua-Hot. Then in 2019-ish, we further refined the Aquahot to have its own thermostat dedicated to the utility bay.
__________________ If "Search this Forum" does not yield answers, please post questions as a "New Thread" (instead of asking privately) so others can benefit from the answers.
Linear Mode
