Upgrading my inverter to a magnum

[Jpheifer]

I have several questions I am looking for information on that would help installation .....

Does anyone have the wiring info that would allow me to identify the wires on the generator start sop switch ( I need to tap into this wiring to gain access to the start stop wire and the run indicator light for my ags) it is my intention to tap these wires at the switch that already is in the control panel in my dx3?




Anyone have knowledge on wether one shunt can be used for both the new battery monitor I am installing and the oem one that is already installed on the unit ?

[Jpheifer]

Originally Posted by Jpheifer

I have several questions I am looking for information on that would help installation .....

Does anyone have the wiring info that would allow me to identify the wires on the generator start sop switch ( I need to tap into this wiring to gain access to the start stop wire and the run indicator light for my ags) it is my intention to tap these wires at the switch that already is in the control panel in my dx3?




Anyone have knowledge on wether one shunt can be used for both the new battery monitor I am installing and the oem one that is already installed on the unit ?

Well first stage is done the new inverter / charger is installed and operational - next up is the AGS( automatic generator start) I hope to get this installed today or tomorrow ...... after that the battery monitor module ( waiting for a couple parts to finish that ) then the upgrade should be complete . Oh and I also have to replace the ATS ( as it has started to fail ) part is here just need to install.

[Jpheifer]

Originally Posted by Jpheifer

Well first stage is done the new inverter / charger is installed and operational - next up is the AGS( automatic generator start) I hope to get this installed today or tomorrow ...... after that the battery monitor module ( waiting for a couple parts to finish that ) then the upgrade should be complete . Oh and I also have to replace the ATS ( as it has started to fail ) part is here just need to install.

Stage 2 complete - ags is attached and ats is installed all that’s left is some programming and get used to using it and to get the battery monitor hooked up( waiting for parts)

[AWF1945]

Hope to see some pictures of the new setup. Auto transfer switch (ats) I guess is what your referring to?

[Jpheifer]

Originally Posted by AWF1945

Hope to see some pictures of the new setup. Auto transfer switch (ats) I guess is what your referring to?

I will post pictures soon and yes auto transfer switch