So over the weekend, we went on last outing before old man winter hits. I put the dinette down to create a bed and all was good until later when it collapse. The gap between the benches are a bit bigger then the table. Why did they do that? Because of this, the end of the table broke as it landed pretty hard on the floor.
Only thing that I know you can do is call FR your Div. and ask them in parts. Or you can have one made (which might be better being that one didn't fit) by a cabinet shop. Take what you have left so they can get measurements and the stain color right. But measure the correct opening first. Sounds like the factory didn't set the furniture correctly, and for sure never put it down to made sure it fits. Back to Q/C and FR. I know they buy that stuff premade but someone should have checked. here is a list if I can post it with the FR #'s , called the warranty Manager first for your Div.
Our table was the same way when we got ours. It barely reached the supports but would slide right off. I but on another board making the support larger to fix. I've heard of this issue with nearly every 195bh.
Linear Mode
