366FL Hydraulic Cutting Out...help!

[jb4xx]

Two hydraulic slides and front landing jacks keep cutting out. We have to keep clicking the button over and over until they finally extend.

Think its a switch or solenoid?

[brad2388]

How long does it run before it stops? Theres also a breaker that trips but resets as well.

[NMWildcat]

I had the same exact problem a few weeks ago. For me it was the auto reset fuse(s). Was two of them connected by a bus bar. Was between the battery and the hydraulic motor. Works like new now.

[jb4xx]

Is it the breaker? I think there is two of them. Where did you buy yours?

[brad2388]

If its cold outside i believe its normal. But you need to check to make sure it was a 50 amp breaker. I believe some came with the wrong size.

[jb4xx]

Originally Posted by jb4xx

Is it the breaker? I think there is two of them. Where did you buy yours?

Is this it?

[brad2388]

Originally Posted by jb4xx

Is this it?Attachment 190171

Thats not it.

Heres the letter from lippert on it.

https://www.lci1.com/assets/content/...ulic_Pumps.pdf

[brad2388]

Originally Posted by brad2388

Thats not it.

Heres the letter from lippert on it.

https://www.lci1.com/assets/content/...ulic_Pumps.pdf

Heres the upgraded 80 amp breaker.

Bussmann CB185-80 Waterproof High Amp Flush Mount Type III (3) Circuit Breaker (80 Amp), 1 Pack https://www.amazon.com/dp/B001PTBVLW..._u9r1BbTD6D4QY

[NMWildcat]

Originally Posted by jb4xx

Is it the breaker? I think there is two of them. Where did you buy yours?

This is what the two of mine look like. They are connected by a copper strip in my setup. 50amp 12v auto reset circuit breaker. Can get them at any auto parts store. $12-$15.