Quote:
Originally Posted by BayouDude
The coupling between the hydraulic pump and the electric motor has failed on my 2009 32qbss wildcat. I took the motor off and was able to spin the pump enough with a drill to retract the bedroom slide. The living room slide is not budging . Any suggestions?
|
Did you do this?
Remove the brake assembly from the motor. Use a screwdriver to remove the screws that connect the brake assembly to the motor. Don’t lose the screws. Set the brake assembly aside.
Find the crank extension. The crank extension is located either on the outside or the inside of the frame. Refer to the owner’s manual for the exact location.
Attach the crank handle to the crank extension. The crank handle comes with the trailer. If the crank handle is not available, use a wrench or socket and ratchet to turn the crank extension by hand to extend or retract the slide-out.
Reattach the brake assembly to the slide-out motor. Replace the screws and securely tighten each one with the screwdriver. The brake assembly prevents the slide-out from moving.