I would like to how how much clearence is under the garage floor in order to mount wheel chocks for motorcycle with screws, maybe toggle bolts due to the bottom being sealed. Thanks in advance.
I spoke to Forest River. Tanks are tight to floor in front part of garage. Would need to drop tanks to install chock mount. Don't drill floor! I will attach wheel chock to piece of angle and attach the angle to the tie downs already in floor.
Dagwood
If you use the HF chock you may have to replace the rocker. Was to narrow for my Valkyrie. Used one from Pit Bull $60. $50 for HF plus $60 for pit bull rocker still less than Pit Bull or Condor. Also put 2x2 in vertical so tire does not wedge in it. Welded a bolt to the center bottom which slides thru the tie down to secure it. Couple of big washers and a lock nut. 2 minutes in or out. I use floor tie downs for front and rear not HF tie points. To narrow and soft ties could damage bike when on HF. Couple other things on loading a bike. I put 2" non slip tape from Ace Hardware where the back wheel grips to push up on rocker. Spin your wheel one time and plastic flooring melts. Also I use a stack of 2x4's in front of rear wheel up to the frame to stabilize. Found out the hard way the straps will slip.