2015 Roo Interior Lights

[gbrian0118]

I need help, please! Can anyone tell me how to remove the cover from these lights, cussed things. Workers left several of the lights full of tiny pea sized particles of ceiling insulation and I can not figure out how to get them off so I can clean them out.
Note to self, next purchase know how to do this before leaving the dealership!

[gbrian0118]

Here is a picture

[syogerst]

Good luck, I have the same problem!Some say to push lens to the center to unlatch, but the lens in mine are hard plastic and don't bend at all. Called the local CW and they couldn't budge them either. Mine are full of small plastic shavings. Sure hope we get an answer.
Roo23 IKSS 2015

[DK-in-SC]

Me too. I tried this weekend to get one off and after a few minutes of struggling, I decided the little styrofoam pellets didn't bother me any more.


Sent from my iPhone using Forest River Forums

[Purdyquibb]

On mine, That were full of course. I had to basically just squeeze the lens from the side so the plastic tab would clear the housing. They are stiff but I didn't have any issues getting them off. I used a small flat head screwdriver and just pried it in and down. If you push the lens to one side you can see the tabs that hold it in place.

[gbrian0118]

Originally Posted by DK-in-SC

Me too. I tried this weekend to get one off and after a few minutes of struggling, I decided the little styrofoam pellets didn't bother me any more.


Sent from my iPhone using Forest River Forums

DK you are too funny. I'll keep trying. I'm just about to the point of using that 10oz adjustment tool. LOL

[gbrian0118]

Originally Posted by Purdyquibb

On mine, That were full of course. I had to basically just squeeze the lens from the side so the plastic tab would clear the housing. They are stiff but I didn't have any issues getting them off. I used a small flat head screwdriver and just pried it in and down. If you push the lens to one side you can see the tabs that hold it in place.

Thanks I'll give it a try.

[Mark Ulmer]

Originally Posted by gbrian0118

I need help, please! Can anyone tell me how to remove the cover from these lights, cussed things. Workers left several of the lights full of tiny pea sized particles of ceiling insulation and I can not figure out how to get them off so I can clean them out.
Note to self, next purchase know how to do this before leaving the dealership!

If you look around the edge of the housing right where it meets the ceiling, you will find that there are 2 small slots (about 1/4" wide or so--maybe a little less) on each side. I find that a flat-bladed screw driver inserted into one of these slots and then twisted slightly usually pops off the light cover pretty easily.

[Jimandchris]

I was able to push in from the two small ends and they did pop off, was easier than i expected.

[gbrian0118]

I'm in yippee! Thanks everyone for all the help.