Tested out my Blue Streak install - worked perfectly. Installed an Oxygenics shower head. Test spray was amazing.
Finally, after 7k miles, I repacked the bearings and checked the brakes. The picture below is representative of all four assemblies. Only one showed signs of a slight grease leak at the rear seal. But the leaked grease was hardened and dried out so I suspect it was left from the original assembly. The bearings were well packed and there was no sign of overheating. I cleaned the bearings and repacked the good ole way in the palm of my (latex gloved) hand. Installed all new seals. The first seal took about 15 minutes to remove! All of the brakes were adjusted fine.
Lee and Anne
2016 F250 2WD CC SB XLT 6.2 3.73 3,295 lb payload cap.
2014 Salem Hemisphere 282RK 8k lbs loaded, Equal-i-zer WDH, TST 507 TPMS
2016: 33 nights camped; 5 nights booked