Just got an A122 that is couple of years old, and getting to know it.
Initial impression is good, and I like the design overall, and the quick up and down for setup and takedown.
I put a bicycle rack on the rear bumper/frame with some 2" x 2" angle iron, and I'll post pics of that when I get time. Lots of drilling work, but works fine.
I have a question:
The hitch post has the round metal plate on it, and when I went to put the wheel on, it would not fit. It looks like the round post is too big a diameter to fit into the wheel tube. What could be going on with this?
Under the right side dinette seat, the hole to lift up the wood had a rather sharp edge on the bottom of it from the plastic insert being too long and roughly cut. I grinded this, and it is no longer an issue.
I have not found anything else on the negative side, and all else if positive!
So, first couple of days getting to know it has been good, and I am pleased with the camper. Looking forward to much more getting to know it.