I am getting ready to add a connector for my satellite dish. I found a real nice cable connection point that I will add in the same area as the cable input. I am going to add the Leviton Quick Port connection points inside one of the cabinets.
My question is, what are you using to cut holes in the wall board material? The material is kind of flimsy and it is in a tight area. I have a roto-zip and could make a template but these are quite messy. I will be using the low voltage mounting brackets (Arlington LV1-1CS Single Gang Low Voltage Mounting Bracket Device - Amazon.com
) for mounting the plates instead of full boxes. I would like to make a nice accurate opening for them.
Thanks for any help/ideas ahead of time, I know someone will have just the right idea for me.