Wildwood Cable input?

[aaronh7]

I just bought a 2010 wildwood xlite 26bh. do they all have a cable input jack? Where is it located i cant seem to find it anywhere?

[Herk7769]

Look for a square flip up door with coax connectors in it. If there are two connectors one is for cable and the other is for Satellite.

The Satellite is a "home run" cable to a wall pad. The CABLE one goes to the back of the roof AMP wall plate. To enable the cable to work, you have to turn off the amp. (Green light out).

[aaronh7]

the only thing i have on the side of the trailer is the power cable and the water connection so i am assuming my trailer is not prewired for cable hook up. I guess i should have looked a little more closely before i purchased it.

[Herk7769]

Do you have a roof antenna and a powered amp plate?

[aaronh7]

yes

[Herk7769]

http://www.winegard.com/kbase/upload/2451486.pdf

The rear of the amp has three downward pointed coax connectors. The center one is the cable TV input. Make sure there is a cable there. If not you can add one. It is selected by pressing the little button and turning off the green light.

You can run a cable from that center connection to a convenient spot outside the camper and mount a waterproof box there. Winegard sells them or you can buy one at an RV store.

[aaronh7]

thanks for your help i will definately check into that

[MtnGuy]

My cable hookup is just a coaxial connection covered by a rubber plug, with about a 2" round plastic frame around it.

[leencharlotte]

Originally Posted by aaronh7

I just bought a 2010 wildwood xlite 26bh. do they all have a cable input jack? Where is it located i cant seem to find it anywhere?

I have a 2011 Wildwood Heritage Glenn and my connections are on the back of th trailer rather than near my water/ elec hookups.

2011 Heritage Glenn 312QBUD

[cessnajo]

I have a wildwood sport and it has cable input and a sat. Input at the rear of each side.They just have a rubber pull covers on each one.But mine is aluminum sided.