Maintenance for Columbus 365RL

[Rmk2001800]

Well I have had the Rv for 3 years now and figure there has to be some Maintinance that needs preformed with the sides, axles and ????? What is the list and how do I complete them? I haven't done anything with the slides yet... Axles I have greases but I could tell the breaks were getting weak.

[jonwisconsin]

Have you checked the caulking around?
Also, when I was at the factory, they recommended CRC White lithium grease for the slide gear.
I'm sure others will have some suggestions

[Rmk2001800]

Who do you even lube the slides?

[jonwisconsin]

I'm trying to understand your question. If you meant how to do it, there are some videos in YouTube.

[donanddona]

Clean and lube all rubber seals around my slides yearly. Some have said to powder them but I do not. Lube the landing gear. Electric ones have grease zerts inside upper arm. Very hard to reach. Hydraulic ones need motor oil on the sleeves . I remove the top caps on my landing gear to pump in some grease there too. Spray the rear stabilizer and all stems on dump valves twice a year. Additionally, I spray lubricant in my front door latch too. Don't forget to lube the roof antenna (gear) with spray lube.

[donniedu]

You have to remember Lippert uses plastic bushings in all of the suspension swivel points. They typically are worn out in 6 months.
Wash, wax, inspect roof and all seams and reseal as necessary. Lube slide out components. Your good to go then.