What is it you are trying to do? Is there a specific issue you are working on?
We recently purchased a Tailgater satellite system - I haven't received it yet, but expect it in the next couple of days. We are trying to figure out how the satellite will wire from the rv input to the tv.
Satellite hooks up to cable input on outside of trailer then not sure how to hook up receiver to tv. Any advice?
I have a 2013 Sabre 34REQS-6. What is the problem or what are you trying to accomplish?
We recently purchased a Tailgater satellite system - I haven't received it yet, but expect it in the next couple of days. We are trying to figure out how the satellite will wire from the rv input to the tv.
Satellite hooks up to cable input on outside of trailer then not sure how to hook up receiver to tv. Any advice?
We don't have SAT but if you look where your antenna booster is you'll see it has 2 coax jacks. Bottom one is for roof mount antenna. Top one is labeled Aux/Sat. I'd hook up a coax cable from that jack to your receiver and a coax cable from the receiver to your TV. Make sure the antenna booster is turned off (no green light) when using SAT reciever.
I to have tried to run a Directv system through the cable connections on my 34REQS6. Here is what I have learned on my tt.....I can't get a signal through either connection for cable or sat service. Booster turned off. Run separate cable from dish to box then to tv and all is fine. I'm pretty sure wiring in tt is not right but I'm not going to tie it up at the dealer for a month for him to try and figure it out. HDMI cable is only option to hook box to tv.
TV Wiring in Sabre 34REQS-6
Linear Mode
