Booth table

[Moosure]

T21 twin bunk high wall (no dormer) - has anyone been into the wall between the booth & front storage locker? Do you have pictures?
I'm wanting to mount a flip up table top on that wall. It would be like the one beside the burner top, only slightly bigger.
I have no idea what is in that wall or where any support "studs" might be.
Any suggestions on best approach?
Thanks for any input you have!

[OYO]

Mine is wood, but i don't know how high. The table brackets are solid.

You'd have to do an exploratory with a small nail/brad. Or if your ears are good, the tried and tested tap test.

[Moosure]

I see that a few people looked but only OYO responded. Thanks, OYO!
I took his advice and did the tap method to locate structure behind the wall. I discovered that there were vertical "studs" inline with where the booth seats met the wall, plus, one in the center (there was a white screw in the wall already there). I mounted a 1x3 across the top to all three vertical "studs". Then I connected the lower part of the shelf brackets to a shorter 1 x 3. This support was only screwed into the center "stud". This seems to be sturdy enough. We'll see how it stands up to all the vibration it will have to endure.
P.S. The camera has messed with the perspective; the outside screws are directly over the front edge of the booth seats



Hope that helps someone!

[OYO]

That's cool. Don't think I've seen that mod before