05.....34CKTS kitchen slide

[Jim Spence]

Hi all... My kitchen slide has a plastic strip on the outside that it slides on ( a half round raised area ) that has pushed out. The question is how do I raise the slide in order to get this plastic piece back into place. I have removed all the screws that it pulled through and intend to replace with bigger screws and fender washers. But I need to get the clearance to get that strip back into place TIA for any and all help

[Platokidd]

got pics

[Jim Spence]

Not at the moment it looks like a piece of channel iron except plastic so it looks like I have to slip it over a ledge but it only fastens with a line of screws. I raised the outside edge with the adjuster bolts about 1/2" or more and have a set of slide jacks at each side so going to try to see if I can tap it back in there.. I can see a bunch of dog food under there I need to vacumn or blow out ( previous owner )

[tumbleweed1]

If you can get a Jack under something you can. But be careful.I had a similar thing happen a few years ago in a bedroom slide. A porter power or something like that helps. Fixed my problem.

[Jim Spence]

Well it went back in but wasn't easy. It now has twice the amount of screws with fender washers on them

[tumbleweed1]

:thumbup: