Slideout issue and LCI multifunction issue

[Wildwood19880608]

I have a 2015 272QBXL. I have power to the controller and the wall switch for the slideout. I do not have power to the slide-out in and out wires (blue and green) on the LCI multifunction that is located under the fuse box in my trailer. All fuses have been checked.

Anyone have the wiring diagram for this because the stickers installed from the factory only say + or _ on the bottom posts and therefore I have no clue what all that is for? Any help is greatly appreciated.

[Bama Rambler]

You have a Schwintek slide out system.
Does the controller have any blinking lights on it?

Can you post a picture of the controller and the motors?

Here's a copy of the Schwintek In Wall Troubleshooting Guide if you don't have one.

[Wildwood19880608]

These are the picture requested. I am having trouble with finding out what the wiring diagram/schematics are for the bottom of the 5 output receiver. They are only labeled as (+) or (-) and nothing else.

I have zero power for the wires that need to tell the controller to let the motors go in or out.

Full power to the wall slideout switch, and power to the controller, but nothing happens when you push the wall slideout switch. No motor function and the controller does not flash any lights. Hooked up new controller and so I know that is not the problem.

[Wildwood19880608]

Yes I have a Schwintek slideout system.

[Bama Rambler]

That unit is the remote receiver. There should be fuses on it. Have you checked the fuses on the receiver as well as the short stop that's mounted on the board?

There will also be a fuse or short stop feeding the board. It's usually near the battery(s) but you'll have to trace it down to find exactly where it's located.