Originally Posted by MaxMotoDad
2018 dx3 bh rear bedroom slide not _fully_ completing the slide out process. As you can see the trim lower section is not fully out and I can feel a gap when touching the rubber seal behind the trim. Where do I start to adjust this? Looks like an accuslide cable system.
When the slide is out, looking at the four (4) physical cables - they look OK on the portions that I can see. Though I realize there are a lot of cable-lengths behind where I can't see...
Does it stop there. Hard to tell from your picture...the 4 cables that you see are the retract ends of the cables, there are more that extend the slide. You have to remove the trim over the slide and you will find the motor, chains and cable adjusters there.