Pax power seat 12v power 2015 Force 37BH

[Jetjockey6]

Anyone know where the 12v power source is for a 2015 Force 37BH pax power seat? Drivers seat has correct power and seat functions; pax seat has no power
at the connectors coming up thru the carpeting. There is one 20amp fuse,12v, in the electrical panel on the side of the aft bed labeled “P/S pwr” but only one.
Ignition key on/off, engine on/off, genset on/off makes no difference. Pax seat wiring appears intact, (bare steel floors at the moment due to water damage),
connectors intact, etc., but no 12v power.

Jim
2015 Force 37BH
Seattle

[MasterBlaster]

Jim have you tried to trace the wire thru the floor and see where it goes? The wires are usually numbered also, does the driver and passenger seat have the same numbers on the wires?

[Jetjockey6]

The wire numbers are:

pax: E336914

Driver: E336814

Given the above would/could the power source be the same?

Jim
2015 Force 37BH

[MasterBlaster]

It is most likely that both seats run from the same power source, I know in a car/truck their is not a fuse for each seat. I think I would see if I could get power to the seat via a jumper wire from drivers seat and make sure it works first. Then if all check out I would trace your power wire from pax seat and see if it is damaged.

[Jetjockey6]

The leads coming out of the floor for the drivers seat show normal 12v power. Leads for pax seat show nothing. I connected the drivers seat leads to pax seat
and the seat is still inop. ReChecked the drivers seat leads and they were powered. The cab was flooded in December so it appears that water entered both the floor leads and the apparatus that moves the seat itself. Just have to dig into it.
Thanks!

Jim
2015 Force 37BH