2022 Sunseeker 2400B Wiring Diagram

[KHois]

Hello, I am looking for a wiring diagram for a 2022 Forest River Sunseeker 2400B. Wanting to do some drilling into the walls and need to make sure I'm not going to hit anything behind there. Thanks!!

[BehindBars]

Since you posted this in the MBS chassis forum, are you asking about a Mercedes-Benz wiring diagram?

If you’re asking about the Sunseeker house wiring, it would make sense to post in the Forester and Sunseeker forum. Except for a wire passing through for an exterior light, outlet, camera, or TV outlet, there are no wires in the outside walls. Motorhomes are built from the inside out. The large cabinets, plumbing, and wiring is done before the exterior walls are installed. For interior walls, look to see what else is mounted in the wall that might potentially have wires in the way.

You can look at the sticky thread in the Forester and Sunseeker forum for model specific diagrams, but I doubt you will find any wiring schematic.

[DaveJordan]

Yup, OP is asking about the Forest River wiring of the MBS based Sunseeker 2400B. Not likely to be too similar to house wiring of non-MBS units.

That being said, wiring diagrams have been hard to come by. You might check the Solera forum as I think a few diagrams from 7...8...9 years ago may be available there. One other thing to note is that the FR wiring diagrams are not terribly clear about exactly where various wires are run.

Probably the best way to find out is to look in cabinets and such...pull out the drawers, etc. You might also ask about a specific area where you're wanting to drill - someone may have knowledge about it.

Good luck!

[BehindBars]

To further clarify where the wiring might be found, regardless of what chassis your motorhome is built on, the below picture shows a Georgetown motorhome, as an example, in the process of being built. Note that the wire, furnace ductwork, and plumbing are routed through and behind cabinets, and in chases before the exteriors walls go up. So if the question is where is the wiring in the exterior walls, there is none, unless a penetration is needed for a specific exterior device.