Added side marker/turn signal (LED) clear lens mounted over rear wheel well opening
Interior
Insulated the cab floor and "dog house" for noise and heat through floor.
Insulated the top nose cone
Replace all of the electronics ( radio and tv)
Custom built TV "box"
Installed passenger seat swivel- so it can face the interior
Customizations
Added Banks headers and intake mods
Brazel's Ultra Power performance mods to engine management
Brazel's installed Safe-T-Plus Steering unit / Rear Trac Bar/
Front end alignment
Rebuilt rear bed platform to take a residential Full size bed (these units are advertised as queen sized bed - not accurate) used a full sized sleep # bed with two zones. mounted pump inside night stand (passenger side).
All LED inside unit
installed new lower unit to RC Circuit board, that provides stepped battery charging
Installed Progressive EMS Hardwired 30 amp unit with remote monitor.
Installed Go Power 300 Watt Pure Sine Inverter- routed electric plugs in front of unit for TV / etc. and by bed. These plugs 3 of them are uniquely marked and specific to Inverter circuit
Installed 2nd Fan-Tastic Fan
Took out 2- 12 volt wet batteries and installed 2- 6 volt AGM
Hi,
Getting ready to install my new fan and am wondering if you know which of the wires (if any) to use for power. Took the inside bezel off and have 2 sets of wires, one white and blue and the other white and purple. Any help would be great!