Rockwood ultralite

[rgood]

Have 2013 Rockwood Ultralite. Wondering where the antenna power booster is located if I have one and also have switch under overhead cabinet to left of front door as you enter. Can not figure out what this switch does. Any help out there?

[Rdeejr]

I have a 2017. The switch on mine where you are describing turns the awning led lights on

[rgood]

Originally Posted by Rdeejr

I have a 2017. The switch on mine where you are describing turns the awning led lights on

Thanks. I don’t have awning lights but there is wiring for them and it makes since.

[rgood]

Originally Posted by rgood

Thanks. I don’t have awning lights but there is wiring for them and it makes since.

Not to bother you again but when I looked not sure how they would plug in, if I had them. I can see the wiring down the awning arm.

[rockfordroo]

Assuming you have the usual crank up Winegard antenna, you should have a wall plate where the antenna cable from your TV plugs into the wall. Looks like this:



The little button on the right turns the booster on and off; there's an LED that lights when it's on. (Note: The booster is actually in the antenna, this just turns it on and off.)

I've attached a manual for it.

[rgood]

Originally Posted by rockfordroo

Assuming you have the usual crank up Winegard antenna, you should have a wall plate where the antenna cable from your TV plugs into the wall. Looks like this:







The little button on the right turns the booster on and off; there's an LED that lights when it's on. (Note: The booster is actually in the antenna, this just turns it on and off.)



I've attached a manual for it.

I have the wall plate but nothing is plugged into it yet tv works. I don’t know.

[XenoRev]

Originally Posted by rgood

I have the wall plate but nothing is plugged into it yet tv works. I don’t know.

You have to have the power on for the antenna to work. The amplifier passes very little si gnal without power.

[fonzie]

Originally Posted by rgood

I have the wall plate but nothing is plugged into it yet tv works. I don’t know.

That is because TV is connected in the back of the plate.

[rgood]

Originally Posted by fonzie

That is because TV is connected in the back of the plate.

Thank you so much. I thought that was the reason as all of the wiring goes through the wall. Older but fairly new to RVing but love it. Still learning .

[Hoyt]

Originally Posted by rgood

Not to bother you again but when I looked not sure how they would plug in, if I had them. I can see the wiring down the awning arm.

I suspect you have a power awning? And the wires you see are for it? just guessing.

[rgood]

Originally Posted by Hoyt

I suspect you have a power awning? And the wires you see are for it? just guessing.

You are right. Figured that out after sending message. A little slow . Thanks