Do over on the front AC

[rdrman08]

We bought a 2008 FR Berkshire back in 2018. Along with a bunch of other "projects" repairs something every time... I always wondered why the replacement brisk air II front AC had the manual control knobs when there's a controller on the wall that will run 2 zones. I'm pretty sure it's the CCC 1st version (5 button). So thinking how hard could it be? I ordered what I thought I needed to just change it back to the original configuration. I bought the matching Air Distribution Box (3105935.039) and an electronic controller (ccc interface relay box 3109226.005)... Everything seemed to be going ok until it was time to test. The AC doesn't come on but I can hear clicks from the controller box. Sure could use some awesome suggestions short of calling the local RV repair guy.
TIA, Randy Baker
I'm trying to figure out how to post some pictures from my google photos ap

[rdrman08]

[rdrman08]

Hey all here's some pics of the rear bedroom ac. It's the original penguin II 1350btu. It's controlled by the CCC controller on the wall in the galley. There's a temp sensor on the wall next to the door. Pretty sure that's connected to the 2 wire molex that runs into top section. I'm seeing more than one data cable here I'm not sure if they were reconfigured to work with the manual controlled air brisk II 1500btu in front ac position...

I checked the breaker for front ac I've also plugged the com wire into both ports on the electronic controller... I've reset the controller everytime I changed anything. I'm getting clicks from the new controller and the controller is seeing the new controller board. All dip switches in the on position. Didn't see dip switches on the penguin are they on the roof?
Well that's what I got anybody into a challenge?😳