I have a Powerwinch 3000 on my 2015 HW 296. I’m in process of selling but want the lift to work. It will lower but once the up button is pushed nothing happens. Where do I start to dissect this problem?
I have a Powerwinch 3000 on my 2015 HW 296. I’m in process of selling but want the lift to work. It will lower but once the up button is pushed nothing happens. Where do I start to dissect this problem?
The key pieces might be the switch, the double relay board under the winch itself (take off bottom cover)
and possibly the limit switch (accessible from top cover).
I have a Powerwinch 3000 on my 2015 HW 296. I’m in process of selling but want the lift to work. It will lower but once the up button is pushed nothing happens. Where do I start to dissect this problem?
I had the same problem a couple years back on my 2016, 2516G Rockwood Premier. It was a bad relay. I contacted Carefree and they replaced it at no cost. The install took a little time but once I replaced it the problem was resolved.
I had the same problem a couple years back on my 2016, 2516G Rockwood Premier. It was a bad relay. I contacted Carefree and they replaced it at no cost. The install took a little time but once I replaced it the problem was resolved.
I had a similar problem mine would go up but would not go down it ended up being the switch
Linear Mode
