MOD Guy

I have a235rs would like to change steps but know what to get .wonder if you had changed yours and what brand they where

Hi MOD Guy,

I found this post from you this morning and I've been dealing with the same issues. On the front side of our rear slide the water will go down the side or slide seal and make its way back and drip into my rear storage compartment. For now I've been putting a towel down and keeping the nose high. Have you found any other options? Seals all look good.

We had some water come off the slide as when we closed it yesterday. I thought it might happen so I checked immediately after closing and saw it dripping so I moved the cushions and put down a towel over the couch. I may need to invest in a ladder.

Paul
"x2.
I always keep ours 1/4 bubble high in the front. Water can and will get under the outer top edge of the slide "seal" when the slide is out. It is more of a flap than a seal. When water runs down the sides, it can be held by suface tension and run on the underside, back toward the camper, and possibly get past the rubber flap on the underside. Guess how I know"

Hi, I have a 2012 SV235 RKS and I was wondering if you new how to attach extra cabinets to the exterior wall. You appear to know what you are doing and I am hoping you can help. As I understand it the wall is bonded with foam so puting a screw into the wall scares me a bit. I dont want to have a delamination problem and then have Forest River say it was my fault. Thanks for any help. Also I think you did a mod with the empty space under the pantry in front of the shower. I cannot find those pictures and was hoping you could send them to me. hiflyer901@gmail.com. Thanks again

David,
Where my camper is stored, I can't deploy the slide out. The next time I have it pulled out to go camping (the end of July), I will get some pick and send to you. The lower rollers look much like the top rollers.

Hi - we have a 2005 Wildwood T25RS. Our problem is not as complicated as yours. The rollers on the lower edge of the slide out were replaced by the previous owner and are not OEM. There is some component along the lower edge that is missing - could you take a few photos of the lower outer rear rollers on your unit for me? My e-mail is dave.king@meaforensic.com. Thanks a bunch.