Forest River Forums - Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: DavidMort

Forum: Dynamax

02-19-2023, 01:26 PM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

Just a note if the slides do not set in my...

Just a note if the slides do not set in my experience (3 times) the motor step encoder on the top of one of the motors fails due to twisting of the motor pulling on the wires, unseating of the...

Forum: Dynamax

07-23-2020, 10:15 PM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

RE: mostly correct: I am very good at following...

RE: mostly correct: I am very good at following instructions if I have them:)

RE: wipe: I looked at the wipe, I did have the rubber pulled back to access the wires on the inside. It felt like...

Forum: Dynamax

07-22-2020, 10:00 PM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

Motor replacement

Received the new motor from LCI/Slim Rack: $582.96 with shipping.

I moved the slide so it was extended about 12 “. This keeps most of the weight in the RV and you do not have to support...

Forum: Dynamax

07-11-2020, 02:06 PM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

Continued troubleshooting

I was able to access the wiring harness inside to coach.

What I needed to know was that the bulb seal and the wiper seal are glued down with a screw holding the top of the seals to the wall...

Forum: Dynamax

07-09-2020, 06:57 PM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

Slide motor signal check

Got around to looking at the slide issue again. First thing I did was hooked the slide motors from the front slide which is not working to the other controller that runs the rear slide since I know...

Forum: Dynamax

06-24-2020, 08:11 AM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

Manual Mode is when you pull the control pad and...

Manual Mode is when you pull the control pad and use the motor buttons on the back as if your were resetting the stops. When you use these buttons the motors are operating in DC mode. Have to do...

Forum: Dynamax

06-23-2020, 09:18 AM

Replies: 340

Sticky: Slide issue, Slide not working, Isata (Dynamax)

Views: 324,458

Posted By DavidMort

waiting for video

I probably have a bad motor on the front of the main slide. I can move the slide in manual mode so I have a choice on how to access. Inside on the five in the front you cannot access all the screws...

Showing results 1 to 7 of 7

Forum Jump

Disclaimer:

This website is not affiliated with or endorsed by Forest River, Inc. or any of its affiliates. This is an independent, unofficial site.

All times are GMT -5. The time now is 09:58 PM.