Accu Slide Issue

[caflorin]

2015 Berkshire 400QL. My wardroom slide (Accu Slide) stopped working.

- Relays click when I push the wardroom in and wardroom out buttons
- I am getting no power to the motor
- Slide motor and gear box function when wired hot.
- Checked the voltage out of the relays to the motor and it is zero when the buttons are pushes
- Assumption there is a fuse somewhere to

Is there a fuse and/or controlled for the accu slide and where might I find it?

 

[Lincman983]

There is a bank of mini breaker in the inverter compartment. Not sure which one it may be for that particular model and floorplan but here is a print. showing the mini breakers

 

[caflorin]

There is a bank of mini breaker in the inverter compartment. Not sure which one it may be for that particular model and floorplan but here is a print. showing the mini breakers

Thank you. FR got back to me also. Randy mentioned the approx location. Thank you for providing the precise location.

 

[Lincman983]

Thank you. FR got back to me also. Randy mentioned the approx location. Thank you for providing the precise location.

Randy is a good guy glad we got you in the right direction

 

[caflorin]

OK. I found the fuses. All are putting out 12 volts. Still no 12 volts to the relays. The controller is supposed to be in one of the compartments under the slide(in my case accu slide for the wardrobe, rear driver side). The compartments it should be in are for coach service batteries, invertor, and then starting batteries. Still looking, but I see the wires from the fuse exit the invertor compartment and go under the chassis.

 

[caflorin]

OK. I found the fuses. All are putting out 12 volts. Still no 12 volts to the relays. The controller is supposed to be in one of the compartments under the slide(in my case accu slide for the wardrobe, rear driver side). The compartments it should be in are for coach service batteries, invertor, and then starting batteries. Still looking, but I see the wires from the fuse exit the invertor compartment and go under the chassis.

I verified with FR that my accu slide does not have a controller. It instead uses the two 5 pin relays to reverse the polarity or the power to the motor red and white wires. I removed the black tape bundling the wires and white wire separated from the relay socket. I'll draw this up, but my slide was functioning for 10 years with a bad crimp in a connector. Voltage check looks good now. I will finish things up in the morning. Thanks to Randy @ FR and lincman983 for their help.