Hi there.
A few of my rotocast compartments seem like they were incorrectly installed (see the picture below). See how the bottom is lower than the side wall of the RV? And you can see the screw just completely missed the mark. Three of the rotocasts are like this.
My question is, can I bump these up to seal them and then drive that screw in where it's supposed to go? I don't see why not, but wanted to check and make sure first.
A few of my rotocast compartments seem like they were incorrectly installed (see the picture below). See how the bottom is lower than the side wall of the RV? And you can see the screw just completely missed the mark. Three of the rotocasts are like this.
My question is, can I bump these up to seal them and then drive that screw in where it's supposed to go? I don't see why not, but wanted to check and make sure first.
